Fully Automatic Paper Bag Machine Operating Procedures

Nowadays, paper bags are used in all walks of life. Because the Fully Automatic Paper Bag Machine has the characteristics of environmental protection and simplicity, it is very popular. As an Automatic Paper Bag Machine Supplier, today, the company will introduce the operating procedures of the automatic paper bag machine.

First, the preparation work before starting

1. Check for dust and debris around the equipment and remove it.

2. Make a good film roll according to the requirements of the production notice.

3. Adjust the size of the bag according to the production notice and the process file, install the heat sealing knife, and adjust the position of the slitting knife and the heat sealing knife.

4. Turn on the power and set the heat seal temperature according to the requirements of the process documentation.

5. Enter the relevant data for the bag making and the number of pieces required for each tie.

Second, boot

1. Start the main motor, run at low speed, then adjust the edge control and divide the film in the middle position.

2. Adjust the left and right nip rollers to align the left and right films, and adjust the front and rear nip rollers to align the pattern.

3. Adjust the heat sealing knife so that it is heat sealed in the bag's required range.

4. Adjust the slitting blade to the desired position and adjust the punching position to the scissors opening.

5. Initially adjust the speed of the machine, take a sample bag that is flat out, and carry out the initial inspection. If the requirements are not met, take a sample bag that is flattened for heat sealing value test.

6. Finish the bags produced and select the bags with quality defects and bundle them as required.

7. The inspection is carried out by the quality inspector of the machine. After the inspection is passed, the certificate is affixed and sent to the quality inspection room for sampling.

Third, stop

1. Disconnect the main power switch and disconnect the power switch of each part.

2. Clean the machine sanitation and site hygiene, and send the products to the general inspection room.

3. make a good record on duty, to be accurate and tidy.